Monitor mode

See what your policies would allow, hold and block on real traffic before anything is stopped.

Monitor mode checks every tool call against the agent's policy and records the verdict, but stops nothing. Run it for a week or two, read what policy would have done, adjust the rules, then switch it off to enforce.

Turn it on

  1. Open Gateway in the dashboard sidebar.
  2. Turn on Monitor mode under the page title. Org admins and IAM admins can change it.
  3. Keep the agent named in your base URL (/v1/t/<gateway-key>/a/<agent-id>). Calls without an agent are recorded but not checked. The Gateway page shows how many calls in the last 7 days named no agent.

The change applies within about 90 seconds. It covers every agent in the organization that reaches ArmorIQ through Intent Gateway. Agents using the ArmorIQ SDK are not affected.

What changes in Monitor mode

Monitor mode onMonitor mode off
Tool calls your agent receivesEvery call, exactly as the model wrote itAllowed calls only; blocked calls are removed
Each call is checked against the policyYesYes
A held call creates an approval requestNo, since the call already ranYes
A plan is marked failed or heldNoYes
Killing an agent stops its callsNoYes

Responses reach your agent with no added delay: the gateway relays the provider's reply first and checks the calls after.

Read the report

Below the switch, What policy would have done covers the last 7 days:

  • Totals of calls that would be blocked, would be held, and were allowed.
  • A row per tool and verdict, with the policy that decided it.
  • The latest calls policy would have stopped, with the reason.

Plans created while Monitor mode is on show a Monitored chip on the Plans page.

Use Adjust policies to change a rule, then watch the counts on new traffic. When the report only shows calls you want stopped, turn Monitor mode off.

Limits

  • ArmorIQ takes up to 600 requests per minute per gateway key. Each model turn uses one request to create its plan and one per tool call. Past that, a call is recorded as not checked and still runs.
  • A held call shows as "would hold", even if an approval for it already exists. After you switch Monitor mode off, held calls create approval requests, but approving one does not yet release the agent's next attempt. See How enforcement works.

On this page